Counting matching models…
This is a stand I designed for the Elecraft KX3 and PX3. You will need to print two of both STL files to make the stand. I forgot to add the cross brace for the bottom and back. My QRP Club the North Georgia QRP Club offers a very nice…
This is a stand I designed for the Elecraft KX3 and PX3 using Fushion 360. You will need to print two of each STL files to make the stand. I forgot to add the cross brace for the bottom and the back. My QRP Club the North Georgia QRP Club…
I made some changes to the openscad file. I was having problems getting the two side to join and be flush. I added CasewidthAdjusment variable so that the two side could be adjusted to give a little more room top to bottom for the…
I created this cover to protect the solar sheet film when the viewer ( https://www.thingiverse.com/thing:2410792 ) is not being used. I used Fusion 360 for the design. You might have to shrink the X and Y slightly to make a good fit.…
I had a problem with my DirecTV receiver over heating because it was stacked on top of another electronic component. I created this spacer to allow for more air flow between the components. You can add rubber feet to keep it from sliding…
I created a lens cover for the Solar Filter Holder to protect the solar film. Print Settings Printer Brand: LulzBot Printer: TAZ 5 Rafts: No Supports: No Infill: 20% Notes: I used HIPS to print both the holder and the cap. Category:…
This is a tabletop mount for the Small HDTV UHF antenna. Print Settings Printer Brand: LulzBot Printer: TAZ 5 Rafts: No Supports: Doesn't Matter Infill: 20% Category: Electronics
These are all currently available results.
