Counting matching models…
Wer, so wie ich, den Schlauch nicht von dem originalen Adapter lösen kann (ohne den Adapter kaputt zu machen), kann die beiden nutzen, um den Sauger mit einem osvac F32 Anschluss zu versorgen und den Schlauch ebenfalls. Ich habe die Teile…
The yellow part is broken. I tried to glue it together but it lasts not very long so I rebuilt it with Fusion360.
I cut a 1 meter pipe into two parts. The lower part is 80 cm and the upper part 20 cm. You need: 1x Wandhalter Boden (Wallmount bottom) The diameter of the holes are bigger than the pipe's diameter because it has to fit the lid (Deckel)…
I added a small part onto the upper side which should allow one to remove the inlay. Unfortunatelly it has been broken off on my print so it is missing in the picture. I think the reason are my print settings.
In the picture you see the LED bar not fully instaleld because I am currently not sure how to handle the USB cable so I do not want to install the switch yet
I do not like the fact that the cable of the sensor is just hanging around and is exposed to much movement while the print head moves left and right. I think this will lead to a broken cable in the future. This small part will hold the…
A simple holder for the Pipe of the Kärcher WD4. I used 3,0x35 screws
I tried PLA, PETG, some crap from Extrudr, ABS and PP. I recommend PP and ABS as they are the only material which will last in the dishwasher. All other printed models got some extra curves after 1h30min in a 50 degree program in the…
A big clamp for the small arms where the holes are moved 45 degree so I was able to use the small arm as tablet mount
Add an additional layer to your display shelf with these simple shelf brackets.
It can hold four, maybe five clamps. To make it a bit more stable you can screw a 4mm screw into the back. I added a hole for it.
The used TIG filler rods are always laying around on my welding table. With this, I can now organize them easily. I found a pipe with diameter 20-21 mm for which I built that model
I hate it when I go around with my laptop during meetings and always have to ensure that the wireless dongle does not hang around and stresses the USB port. This ugly gadget was my first design in tinkercad. It looks like sh** but works…
Take a look at the pictures to know how to assemble it. YOu need a 7-8mm part of a 1.75mm filament. both parts contain a hole to make it easier to center both parts against each other. I split the stick into two parts to make it easy to…
Recently I bought four level foil. Unfortunatelly I found no existing model on thingiverse and printables that allows the storage of those foils. So I built this small container. I printed four of them. They are a little stackable, though…
I made the bottom out of wood. 4 M3 threaded rods with 1 metre are scrwed into the bottom. The lid fits the end of the 4 rods to avoid that anyone pokes out the eye. Can not describe it better, just look at the photos.
These are all currently available results.
