Counting matching models…
This is an accessory (additional brushes) etc. holder for the Xiaomi Dreame V9 vaccum cleaner. (It possibly also fits to V9P and V10, but I cannot verify). As I think the original charging cradle does not provide enough slots, I designed…
I switched my PC for my Technotrend PCI-E DVB-CT (V7) Card. Now I need to have a “Low Profile” Slot cover. The original, factory made is long gone. May be useful for you. Printed on the side & enabled “Support on Build Plate only”. I…
I printed the (very nice and practical) “Power Supply for Parkside X20V Battery” by mirabatek . I do not need the XT60 port. Therefore I designed covers for the XT60 as well as the USB-Port. There are holes for nuts inside, I did not need…
The hair of my kids often tangle in the Speedy Ear Saver. So I designed a reduced version, based on the one from Mister Thief 117 ( https://www.prusaprinters.org/prints/50063-speedy-ear-save r) It has only 2 pair of hooks, so lesser tears…
My IKEA kitchen cupboard is resting on realtively high legs. Unfortunately, my (iLife) vacuum robot always just goes below the cupboard and gets deactivated. I need to “rescue” it always. These guards are puton the lower frame of the IKEA…
These are all currently available results.
