Counting matching models…
Description The “Stubbie” design by LD.P worked really well, but in common with the commercial plastic anchors I was getting breakages and No. 8 screws tended to strip out the anchor. So I set myself the following design goals: Should be…
Seat Adjuster handle for a VW Polo. Should be printed in PETG. Print Settings Printer Brand: Monoprice Printer: Mini Delta Rafts: No Supports: No Resolution: 0.1 Variable Layer Height Infill: 15% Category: Automotive
WARNING: The Makita CXT batteries do not appear to have built in battery protection, hence you will destroy them if you over discharge them. It is recommended that you fit a 3S BMS as part of your build. The terminals are designed to take…
Remix of the V2 Delta-P duct rotating the inlets to even the airflow. For installation details detail see original model by teookie. STEP file included. Print in ABS/ASA with 4 perimeters, no supports needed.
I needed a set of covers in a new colour, these are an exact replacement for the existing. Print in the orientation of the STL, using paint on supports as shown. I set the "Top Z contact distance" as 0.15mm to allow easy support removal…
Clip to stop the pin on a Kitchenaid mixer sliding out. Best printed in PTEG, but PLA will work. Thanks to @ShoelessScoo_1148702, there is a retention screw accessed from the bottom of the mixer that should be tightened to resolve this…
These are all currently available results.
