Counting matching models…
Really like this design but the screw hole was a bit "over-sized" for a 4-40 x 1/2 screw. Put some more "meat" in the holes and reduces the nut size so it properly holds a 4-40 nut and won't spin. With the more meat the screw does not…
I was blown away by the cost of an OEM Waist Level Finder for my Mamiya 645 Super. I don't use one often but when you want one you want one. So I came up with this. I will probably replace the front tabs with 1mm stainless once they break…
I been working on this lil project also - a Poorman's JOBO. Works with all the tanks I tested and or own Nikor, Patterson, Yankee, GAF. I kept this a simple as possible. I started out with and Arduino controller and a bunch of other BS I…
Scaled to fit a Stainless Steel Nikor Developing Tank. Push load type reel. Helps to taper film of feed end OTHER SIZES ARE HERE 110/16MM - https://www.thingiverse.com/thing:4831133 17.5MM HIT - https://www.thingiverse.com/thing:4831135…
MIFO - Semi-automatic Film Processor (Why MIFO? Why JOBO? - Find the answer to Both) Well Here it is, a semi-automatic temperature controlled water bath film processor. I have included gears for Nikor (Stainless Steel) and Patterson…
Pretty straight forward takes about an hour to print at .20 - .16 - Merry Christmas
Scaled to fit a Stainless Steel Nikor Developing Tank. Push load type reel. Helps to taper film of feed end OTHER SIZES ARE HERE 110/16MM - https://www.thingiverse.com/thing:4831133 MINOX- https://www.thingiverse.com/thing:4831142 This is…
Scaled to fit a Stainless Steel Nikor Developing Tank. Push load type reel. Helps to taper film of feed end OTHER SIZES ARE HERE MINOX - https://www.thingiverse.com/thing:4831142 17.5MM HIT - https://www.thingiverse.com/thing:4831135 This…
Customized version of https://www.thingiverse.com/thing:1039106 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=1039106 I just use the hairdryer and a steel ruler to bend the tabs so that makes a good…
Replacement handle for a Grafmatic 45 Film holder Print Settings Printer Brand: Prusa Printer: Prusa Clone Rafts: No Supports: No Resolution: 0.15 Infill: 25% Filament: eSun PLA Black Category: Camera
Customized version of https://www.thingiverse.com/thing:1039106 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=1039106 I just used a steel ruler and a hairdryer to soften the print so that I can get good…
These are all currently available results.
