Counting matching models…
UPDATE : You can now purchase an improved version of this prop from Blue Robotics! Users should note that this version is slightly larger, and can cause the M500 to draw more than 40A, above the rated current for the motor. This makes…
Real simple, works ok, would love feedback on how to improve! The square cutout for the volume of an 8mm ball is a new feature, tough to get it out and probably faster to just roll balls yourself. Works better after sanding at least the…
The BlueBoat has an innovative hull design, endless expansion possibilities, and open-source BlueOS software, making it the ideal platform for hydrographic surveys and robotics system development. This model is 7% as large, and fun to…
* Disclaimer * This adapter will be under considerable force in testing, and has not been through the typical Blue Robotics testing and development process. It is shared so members of the community can begin experimenting with propulsion…
Great for securing your vessel to a dock or side-tying to a vessel for short term storage. Not rated for lifting, and better to tie to the crossbar if attempting to tow. Happy motoring! Requires M6 SHCS, 20mm length, 316SS recommended. 3D…
The most frequent cause of damaged LiPo batteries is incorrect balance charging. This can occur often in Marine Robotics as a stray drop of saltwater may land on a balance connector during a field battery swap! These protector boxes go…
The Cerulean ROVL can be used to locate your marine vehicle - including the Blue ROV2! The manual provides advice on one way to secure the receiver, as it is important to NOT hang it via the electrical cable. This alternative is a bit…
Print with at least 4 -6 perimeters, petg or better for strength. holds well! Mount base to wall, sand then tap arms into it gently with a hammer. Use appropriate fasteners to mount to the wall - anchors for drywall!
Straight outa R&D skunk-works, these parts are being shared as testing of different solar power solutions for the Blue Robotics BlueBoat progresses. You can adjust the parts for the solar panel you intend to use with the Onshape CAD here…
This part clips to the handle of your Blue Robotics tether spool. When you need to carry it with ROV attached, it provides a place for the tether to be secured and not unwind, to get caught in your feet!
See this link for a full build guide See it in action here ! Print with 4+ perimeters for strength, PETG has best properties for this application. A light application of silicone grease can improve performance. Do not operate the M200…
This reduces the clearance between the frame and the rotating tether spool to ~1mm. This only slightly increases the friction, making it slightly louder when turning the handle to wind up tether . But for both the slim and standard…
The pins on the Grayhill 30-3UL push-button switch was selected for use with the Blue Robotics switch thanks to its high current rating and low price - however the connection tabs are delicate, especially if frequently accessing adjacent…
Load up re-usable desiccant in this holder. Pop a piece of tape around the lid to keep any from escaping. Clip one end around the standoff at the back of a BlueROV2 enclosure, and rotate the part into the housing to clip onto the adjacent…
Print with flat surface on print-bed, as shown in picture with vent installed. Got a spare vent-plug to avoid disaster, but no easy way to remember to carry it with you? Print this and never be caught unprepared! Vent-plug threads into…
Have you wanted to operate your BlueBoat in heavy seas or breaking waves, but been concerned that it might flip over? Have you sent a (specialized) BlueBoat named the SolarTurtle on a missing to travel from Los Angeles to Hawaii only to…
These are all currently available results.
