Counting matching models…
Tolerances are tight. Make extra sure the hinge of the lever that goes into the wing moves properly. The body and the wings have 1 hole each for a 6x3mm magnet to be glued in (the body has it on the inside). The holes on the back are for…
Make sure the base is solid, otherwise it will be wobbly if you use low infill.
Included 2 versions, 1 with storage, and 1 filled. The bell and bell tongue require a piece of string to be thread through. The pattern on the lid was achieved with hilbert curve bottom layer infill and 0.6mm wall thickness on bottom…
Print instructions: For the Balls, walls needed to be thick to print properly so a transparent filament like natural PETG is recommended with a low layer height, part cooling fans ON, and speed set as high as the machine can handle (I…
Make sure the orientation stays the same vertically, otherwise the hinges might fuse. Do not use organic supports, use snug (or normal) instead. Keep in mind that filament is not food safe, so I recommend using a food safe coating.
The top part doesn't need supports. Gluing is best as follows: put glue between top and bottom parts, put glue on the left and right parts, let the left and right parts hold the whole thing together
The flaps/lumps on the sides can create air pockets when resin printed, be cautious. Otherwise printed well. When positioning, make sure the face tendrils are pointed upwards.
On top of the full model, I also included a version with a flat top with a separate head that is easier to print on its back and can take advantage of effect plates and fancy bottom surface infill patterns. I used hilbert curve and a…
Ceremonial Fungal Mask This is a wall mountable piece, I plan on making a wearable version in the future
These are all currently available results.
