Counting matching models…
These things are made to make the suspension harder or softer. I printed it in PLA because it was the only filament I had, but printed in PETG or any other solid filament will be an improvement
Pretty good air flow but i didnt test in a simulation ! Its kinda hard to clip the duct in the X-bracket but once in it its very solid. Print it at 0.2mm layer height and in about 5 to 10 minutes you will get it ! No support required Good…
A replacement part of the Z bearings holder.
This front bumper design allows the front wheels to touch an obstacle in front of the car while protecting the chassis and electronics in your car. It is light but strong, I printed it in PLA and it survives very well but if you have the…
Adjust as you want, but there is a 0.2mm tolerance for theses parts.
These are all currently available results.
