Counting matching models…
Print your own valve caps for your car and bike. This cap fits a standard Schrader valve. These caps have more threads than normal, so they stick better, and you don't loose them. -Print with 0.1mm layer height for good detail -Add a 10mm…
Print approx. €0.21–€0.26 excl. taxPreliminary estimate for one variant
Same outer dimensions as the original knobs on the KO II. This knob fits the slider without using unnecessary force. This model is tried with PLA on a Prusa Mini. Printed with 0.2mm layer height, 15% infill, Prusament PLA Galaxy Silver.…
Print approx. €0.11–€0.13 excl. taxPreliminary estimate for one variant
Small mount for holding Knipex Super Knips pliers on the IKEA Skadis. Easy printing. Support recommended.
Small holder for a wire brush. Not much else to say :)
Small holder for Infrared Thermometer for the Ikea Skadis board. Fits Thermometers with Ø15mm opening. Print with solid infill. The thermometer applies some force on the holder, so I printed with PETG. It works good. The design is focused…
Adapter for Bosch GCM 8 SJL Mitre Saw to vacuum hose 37-38mm. Printed with 4 perimeters. No supports Infill 25%
Printed with PLA+ and it works. TPU or PETG should also work fine. Included Fusion 360 file, so you can make your own adjustments.
Minimalistic tool holder - Fits a deburring tool with a 9,5mm head. Does probably not last forever. Minimalistic design over durability. PETG works fine for me. PLA will likely break fast. No supports. Fast print
Print with supports. Be careful hanging up this massive tool, and make sure your pegboard is attached properly to the wall /s
A simple baseplate for helping hands. I am using these from Aliexpress; "NEWACALOX Multi Soldering Helping Hand" Threads measure at 12,3mm Fusion file included so you can make your own adjustments :) Printed in Prusament PETG Galaxy…
Battery holder for 8 NewBeeDrone Nitro Nectar Gold 300mAh. Can also fit other batteries. Dimension for holes; 7x11mm. This model was printed in PETG, but PLA might be better. Based on thing:3228636
A small mount for a Insta360 Go2 camera for the TinyApe Freestyle 2.5'' drone from DarwinFPV. (An improvement of my other model design https://www.printables.com/model/237689-tinyape-insta360-go-2-mount) +Much easier to take camera in an…
A small mount for a Insta360 Go2 camera for the TinyApe Freestyle 2.5'' drone from DarwinFPV. -25 degrees angle -Space for battery (20,5mm x 14,5mm). Made for Tattu R-Line 550Mah, but may fit others also. -Printed with Filamentum Flexfill…
This cheap little super clamp is great, but the plastic pad is not so strong. Made a design for the small rotating pad. Printed in TPU
These are all currently available results.
