P
Printableskotana
CFMOTO 450MT(ibex) FRONT ABS sensor cover
CFMOTO 450MT FRONT ABS sensor cover I also uploaded a version with the bottom part cut off for drainage. I haven't checked it yet.
- Downloads
- 281
- Likes
- 26
- Rating
- 0
All models
Counting matching models…
P
Printableskotana
CFMOTO 450MT(IBEX) oil drain
CFMOTO 450MT oil drain Machining of skid plates is required. Some skid plates cannot be mounted.
- Downloads
- 136
- Likes
- 18
- Rating
- 0
P
Printableskotana
CFMOTO 450MT / IBEX450 FORK Preload Adjuster
The fork preload adjuster for the CFMOTO 450MT / IBEX 450. It’s designed to fit very tightly, so you need to tap it in with a hammer during installation. Once installed, it stays in place securely unless it receives a direct hit. I’ve…
- Downloads
- 127
- Likes
- 8
- Rating
- 0
P
Printableskotana
DragonBurner for THE 100 v1.1 mount
THE 100 V1.1 DragonBurner Mount The x-axis becomes slightly smaller. (about 16mm) I'm using it a bit slowly. Outer wall - 150mm/s acc 5k inner wall - 250mm/s acc 20k Travel - 350mm/s acc 7k DragonBurner github…
- Downloads
- 120
- Likes
- 27
- Rating
- 0
P
Printableskotana
VORON trident nozzel brush (bambu a1 silcon brush)
My printer is small and needs to be attached on the left side, so I reduced the spacing and adjusted the size.
- Downloads
- 104
- Likes
- 8
- Rating
- 5
P
Printableskotana
THE 100 V1.1 Chamber mod
This was modified by a friend, so there will be no changes later. Modified to add panels to THE100. A hat is also included. All parts were printed in ABS. You can print ABS with THE100.
- Downloads
- 101
- Likes
- 26
- Rating
- 0
P
Printableskotana
Bambu Hotend mount for THE 100 v1.1
The heat sink side is not completely blocked. I'm a beginner in modeling, so I'm waiting for more expert help. It is currently available for use.,
- Downloads
- 75
- Likes
- 18
- Rating
- 0
P
Printableskotana
toggle clamp Spoolholder (2020 profile)
My printer has a built-in spool holder, but it's a hassle to replace. When printing PLA or TPU, I take off the top cover and use this spool holder. Just download the holder from here and assemble it with screws.…
- Downloads
- 10
- Likes
- 1
- Rating
- 0
P
Printableskotana
Takagi RA3 hose reel nipple
Since replacement parts for the Takagi RA3 are no longer available, I designed this replacement inlet nipple. Remove the broken center section with a Dremel tool, then install and secure the new part. A 22 × 2 mm O-ring is required. The…
- Downloads
- 0
- Likes
- 1
- Rating
- 0
These are all currently available results.