Counting matching models…
This is a mount to attach a GoPro to 3030 extrusion. I use it on my Hevo to record with my GoPro Hero 8. Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports: Yes Resolution: .2 Infill: 40 Filament: Atomic Filament PETG…
This is rack mount tabs for a Netgear GS316 series switch. The rear bracket uses M3 screws to replace the existing screws in the back of the switch.
The is a Stevenson Screen that I designed for my Arduino based weather station. The top is designed to install M3 brass threaded inserts. On mine I printed 2 middle sections and a top and bottom to make my screen. I used M3x65mm screws to…
This is a PTT button handle that I designed because I was wanting something other then commercial ones I was finding online. Below are is the button and cable I used. Materials: Red Button Cable Print Settings Printer Brand: Prusa…
This is an LED lamp that mounts to the top of a Prusa MK3 Print instructions Printed in PETG. .2mm Layer Height 20% Infill
This is an adapter for mounting a RAK19007 inside a waterproof box for an outdoor node. Below is the box that I used. The mounting screws are 4mm. https://a.co/d/dFO39KT
This is an LED light bar for an IC-7300 ham radio. I used 5V RGB LED's and a Wemos D1 Mini running WLED to control them. The screws are 4mm. Wemos D1 Mini WLED
This is a tripod bracket to attach a Yongnuo RF-603ii remote trigger to one of the legs. It is designed to fit a tripod with 30mm diameter tubes. You will need a M3 x 25 socket head cap screw and an M3 nut. Print Settings Printer Brand:…
This is an adapter to use malice clips to attach to a chest rig or plate carrier. Below is the link to the malice clips I used. Malice Clips Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports: No Resolution: .2mm…
This is an LED try that mounts to the underside of the X-axis on the Prusa Bear frame. It use M3 screws and M3 T-nuts for 2020 extrusion to mount it to the frame. You then stick your LED strips right to it. Print Settings Printer Brand:…
This is a mount for a Besteker C920 webcam mount. The extrusion bracket is for 2020 but can work on 3030 as well. Below is a link to the webcam this is for.…
This is a simple LED light bar for my Hevo. Below are the parts needed to complete this build. Print two of the mounts and then cut the Screen Tight piece to length, then slide your LED's into the center groove. Please see pictures for…
These are all currently available results.
