Counting matching models…
Remix to add material to sit flat against the side of the printer and two ribs to reduce flex. Print in the orientation of the second picture, no supports required. Printed with 40% infill although less may be fine with the changes made.
Requires 1 of each model and 1 m3x10 to attach the winding knob to the wheel. Hole in the knob is small enough to lock the bolt at the tightness needed for it to wind easily but not be floppy. Fit on the initial version of the wheel to…
I designed this heater/dryer for a space above my enclosure to dry filaments. It can also be used as a chamber heater if the space is available (wall mounted version is in the works to take up less space and direct warm air down). Testing…
I am slowly replacing each blue plastic part on my printer. This is the front panel, there is no drawer. Uses the same 4 socket head screws as the factory part. I printed this with fewer bottom layers and honeycomb infill so you can…
Pedestal for raising 10" planter, base is 11.5". Added columns inside to add strength.
I needed a corner bracket for the top of an enclosure I'm making out of 3030 radiused aluminum extrusion. I couldn't believe the prices of some, and others came with square covers for a radius bracket which made no sense, so I designed…
Remix of 2cm (3/4") male side of snap buckle for permanent attachment. I printed it with 5 walls and 35% infill.
I designed this to mount the fan under the SV07 plus as I was removing the sheet metal to replace the feet. This should be mounted 70mm from the front of the extrusion. Designed to use M3 heat-inserts. You will need t-nuts to mount the…
These are all currently available results.
