Counting matching models…
This GoPro mount can be used on any flat surface with two M4 caphead screws set into the base of the footman, and an additional M5 nut is needed for GoPro mount. Works with both GoPro camera and hard shell mounting points. Originally…
This is a replacement for the inlaid component of the Ring Indoor Camera stem that attaches the wall mount, ball joint, and base cover plate. Print Settings Rafts: No Supports: Yes Resolution: 0.2mm Infill: 20% Filament Used: Prusament PLA
This is the footman for a Jeep TJ hood (small bar in center of hood) to hold down the windshield via a strap. Uses two M4x20 caphead screws, nuts, and washers to mount to existing hood mounting holes. Reuse existing rubber gaskets from…
A simple wall mount for holding 4 spools of filament using 3/4"x12" craft dowels. Craft dowels are secured in place with a #6x3/4" drywall screw. Recommended to mount to stud due to weight of four spools.…
This is a set of parts to repair/replace the bungee anchors and endcaps for a porch rolldown sunshade. Mounting holes made for #6 wood screws. Bungee not included. Print Settings Rafts: No Supports: No/Yes (Needed for pipe endcap)…
This model is designed to reduce potential scratching and paint removal from the cybertruck wheel cover. By using the plug, one is able to pull the cover off using a hook and pick set (which can be used to remove both the plug and the…
Just a simple recliner handle/lever replacement for when yours inevitably goes missing. Designed for a Ashley Furniture Rocker Recliner, but will work with most recliners with a square pegged leg riser handle. Print Settings Rafts: No…
These are all currently available results.
