Counting matching models…
The Model shown in the picture is actually an earlier Version wich I accidentally made too tall wich just wasted Material. I used Pla for this model. Printsetings don't really matter since this part is so bulky.
The model prints with the flat side down and needs no supports but you may have to do some post prossesing do to large overhangs.
This foot helps you grab those bottem drawers easier and can store some smaller things such as a lighter. Note that this is a custom hight and can only be used side by side with the same Module.
All you need are two M2x8 screws to effertlesly carry your remote. I printed mine in TPU but any matireal will work.
This Model will elevate your quad. Print with 15% Infill. To help the stands not fall out when crashing secure it with sippties.
All you need for this small Projekt is a sheet of 6mm pliewood and a pole with a diameter of 15mm. You can also replace both endpieces with more middle ones if you like the look. board dimensions: 16,6 x length 13,2 x length 9,1 x length…
I made this model for a Desk with a thickness of 20mm and a cable with a diameter of 4,5mm. This clip isn't itended as a permanent holder but just for when your not using the cable. I also included STEP files so you can easily ajust…
I was fed up with my pocket ratteling, so i designd this driver to harness the power of TPU. I also made a Stubby version but havent printed it yet so no pictue :(. What you'll need: ridid filament (eg. Pla or Petg) flexible Filament (er.…
These are all currently available results.
