Counting matching models…
Hi, I was struggling to get a working profile under Orca Slicer until they added a base profile for the V3 SE. However, it still did not lay down a proper initial layer and when it did it stopped extruding from layer 2 onwards. I think…
A fresh recreation of a cover concept also including a stand that locks the camera inside the holder. I wanted a cover to use outside and that could easily be moved and stood on various surfaces without falling over. I have used this to…
Here is a simple token to print based on a request. There are 4 versions, with and without holes and the logo as a hole or as raised relief. Size is 8cm long and 5mm thick but these can easily be resized in your slicer.
Needed a replacement leg for a fake Xmas tree support so tried making my first replacemwnt item. Prints on its side for better strength. On an Ender 3 V3 SE with 5% supports and low quality it takes 2 hours to print and it fits perfectly.
These are all currently available results.
