Counting matching models…
It's an older model that I haven't worked on since originally uploading it to thingiverse a while ago, but it was requested that I transfer it over here, so here it is :). Unfortunately I don't have pictures, as the original post doesn't…
Spare Phone case needed! The distance between the mounting clamps is 50mm, it fits a handlebar with a diameter of 32mm . The glue-job does look a little messy, which is thanks to me being a little paranoid about it coming off again, but…
I designed this holder for my electric screwdriver box/ set, it does originally have a whole case that goes over it but I found it to be more practical to just have it “open” and in arms reach, so that I can easily pull it out of its…
I designed this simple case for my Wahoo ELEMNT Roam V3 to protect it a little bit. The buttons are not covered but it should provide at least some protection :) I printed it in TPU 95A, but depending on the printer a softer Material…
I printed the body in PETG and put some epoxy at the bottom on the inside to seal it. The grid is printed in ASA, but really anything else should be fine too, I just wanted to make sure I can put it in the dishwasher on occasion. The step…
This is a holder for the Honeycomb Storage Wall to keep a Sainsmart ToolPac solderring iron: the body, two tips and the allen key for changing the tips. For now there's no included storage for the power supply, I might add that sometime…
These are all currently available results.
