Counting matching models…
Tool holder for the tools included with the Ender 3 v3 ke/Se it clips firmly to the z rail on the right side. I printed mine with 3 walls and 25 percent infill for added stability. no supports are required.
Made specifically for the creality nebula camera for the ender 3 v3Ke and the se with nebula smart kit. The mount Clips tightly on the rail and the base allows the camera to pivot in all four directions, the clip can be positioned low…
Nebula X axis camera mount for ender 3 v3 ke/se gives you a clear view of the nozzle so that you can monitor for print problems and record time lapse videos with the Creality nebula camera. changes from the original include lowering the…
designed to fit the ender 3 v3 Ke with the factory run out sensor. This shifts the spool 90 degrees and centers the weight on the gantry. there is a mount to use with the KE's factory run out sensor. you will need an additional m4 12 and…
stand alone ender 3 v3 ke run out sensor holder to mount the sensor to the gantry if the spool holder has been relocated. easy print ,no supports, I printed mine with 2 walls and 15 percent infill you will need to replace the original m3…
Heavy duty 9mm x 50 bullet case with sliding top and holes to insert 5mm x5mm magnets to secure the top. Warning ⚠ this project takes about 185g of filiment at 25% infill and is not a quick print but, it should hold up for many years and…
sliding bin to catch Purge waste made to fit the creality Hi. supports only needed on the clip, printed as it would sit, make sure model is touching the print bed when slicing. does well in Pla or petg, increase walls and infill to add…
Made specifically for the Nebula camera and ender 3 v3 ke but it may also fit other cameras on the Se model. Base allows the camera to piot in all four directions and the clip can be mounted low enough to see the nozzle. I printed mine…
camera mount for ender 3 v3 se/ke for creality crcc-s7 camera that comes with the creality box 2. requires no supports or any other special instructions and attaches the ¼ printable camera screws available.
this is a taller version of the NorcoT lid riser that I designed for additional cooling, it has the mounting corners By Michel Jubault included in the design, and the slat inserts have be resized for easier assembly.
wall mount for Alesis elevate 3 studio monior may fit other speakers. 14W x 20L outside diameter. the more infill the stronger it will be. no supports or any other special directions. warning, its a long heavy print that takes a lot of…
wall mount usb C cable and flash drive holder
These are all currently available results.
