Counting matching models…
Updated 5/12/24 - Embiggened holes to clear stock attachment screws in the buttpads. I noticed the screws heads seemed larger in the most recent lynx kit I got. Also added 1.25 inch pad option. Updated 5/23/24 - Added an additional…
Update Oct 22nd 2024: Some users reported cracking on the pump bottom. I have uploaded an alternate (Pump Bottom Fix Test) with improved geometry around the hex nuts. Please print this with 99 walls or 100% infill with your best layer…
Updated: 1/15/25 - Added a v2 with some slight cosmetic changes and minor ergo improvements. Updated: 6/12/24 - Corrected some geometry near the magwell that was causing some print issues. A thumbhole stock for the 2.1 lonx. It might work…
Download and use one of Chane's modified shrouds from the linear rail remix. If using a linear rail (reccomended) then also grab the Chance priming block for the rail you are using. If not, then use the stock priming block. Even if you…
***Before doing this mod, consider that the Lynx probably doesnt need a linear rail to help the prime. I made this because it was requested after I made lonx version, but I personally do not use it.*** Update Oct 22nd 2024: Some users…
Make sure your overhangs are dialed in and add supports to the highlighted areas in the picture. A good candidate for using a support interface swap since there are only two layers of connections. Otherwise print as you would the rest of…
Updated 1/15/25 - Added a v2 version that has the finger grip ‘fins’ come up a higher for a more secure hold. Some small changes to the attachment block geometry mean you need to use both v2 parts together. The attachment block sandwiches…
*** Note: I have not actually printed any of these, I just made them in response to seeing a lot of people struggling to fit the shroud for printing. If you have an issue with any of them, please let me know and I will try to fix it. ***…
Cover image shows a before and after on a SCRD drop leg panel. Previously I could only fit 3 speedsloth pouches using D2's molle tabs, with this remix you can get 4 in. Follow all the assembly instructions listed on the original…
Used the female collet dev kit on the 2.1 lonx shroud. To make room for the collet geometry the shroud had to be extended to ~260mm. Since this is likely taller than most users printers, I have also added a split version that will fit on…
Shares pic rail attachment geometry with the stock vertical foregrip and uses the existing hardware for the grip that comes with the SBL2. In case you need to get more, its just two M5x30mm bolts and two M5 hex nuts. Print from the “back”…
These are all currently available results.
