Counting matching models…
I wasn't happy with other bearing covers/flanges I was seeing, so I wrote this scad file to produce this v-roller. Defaults to a good size for a 608zz bearing, but can be customized to whatever dimensions you need. Provided .stl is…
Remix of the 5 way splitter. - split 3 ways - uses M3x8mm screws, countersunk below top of main body.
I wanted to have G2E with the ERCF Twin Sensor support, but without the Filametrix cutter. I'm planning to use the EREC in place of the Filametrix. Currently not tested or printed yet. Length of the PTFE Tube on page 47 of the G2E Manual…
Print with standard Voron settings.
Mold of a typical airgun pellet, sized for a golf ball cannon (1.68in diam). Bolt holes are sized for a roughly 1/2" bolt. Pellet model from: https://www.thingiverse.com/thing:3077740 © cc-by-sa-nc
This is a Remix of Boothy's Manta MK2 duct system for the Ender 3 . I updated some parts to fit better with my setup, as I have a drag chain on my hotend, and wanted to add a connector for the chain. Summary of changes: - Rear_Mount_Plate…
Designed to replace a bottom side clip. This has two screws, so will need to add an additional nut into the frame. Short (stock 8mm) and Long (16mm) screw versions included.
Modified to print as it imports, without support, at 0.12mm layer height.
Set the main body with the Voron recommended parameters, then change the insert parts to your desired settings - I did 0 tops/bottoms/perims and decorative infill for a “ modesty mesh ”. These need a 160mm x 160mm bed or greater, and thus…
Remixed from: https://www.thingiverse.com/thing:4068106 and https://www.thingiverse.com/thing:141354
I wanted to be able to use a Cartographer for the z-probe on my Voron v2.4, but liked the source nozzle scrubber and sheet stops from edwardyeeks. I updated this mod to use a Bambu A1 silicon nozzle brush, and M3x12 SHCS for the sheet…
Print with standard Voron settings, add a M3 heatset and screw in the thermistor.
replacement battery tray for the Volantex Phoenix S 1600. Uses 6x 2mm heatset inserts and 6x 2x8mm screws
Not FAA approved (but is the rubber band this replaces FAA approved? 🤔) Not intended for use in flight.
Annex corner clip with ECAS bowden retainer
Mount for the rear crossbar to move the z-chain out of the way below the crossbar.
Hanger for your aviation headset. Fits in the pen holder, and can spin out of the way when wearing your headset. I find the 9mm version fits the best, but I uploaded a slimmer one also. Not FAA approved.
These are all currently available results.
