Counting matching models…
This pen body is designed to work with the Kaweco Sport Nib Unit . Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: Doesn't Matter Supports: No Resolution: 0.15mm Infill: 15% Filament: any any any Notes: This pen body was…
To achieve 360° rotation on the arm, the servo needs to be modified for continuous rotation. Parts list Drive pods SCE86 Needle bearing Mecanum Hub 33:1 silver spark motor 1/16" Garolite sheet 255mm 85T S3M timing belt 9T S3M timing belt…
Mold for making a loaf of soap for cutting up later. Good for hot or cold process. Instructions Designed for 3/8" thickness material for side walls and 1/8" thickness material for bottom. Holes are ready to accept appropriate length of…
Frame updated: Bearing blocks for motor mounts New weapon plate for motor mounting to prevent breaking of base weapon shaft changed to 1/4" OD added 1/2" ID bearing support for pulley Print Settings Printer: Creality CR-10S Rafts: Doesn't…
Version 1 of Shark Tank Robotics Mega Looon. Ant weight 1 pound Designed to work with the Fingertech Robotics 6inch x 3mm Weapon Bar. Parts List: 15 tooth Fingertech Pulley 30 tooth Fingertech Pulley FingerTech 6inch x 3mm Weapon Bar…
This is a mold form to create a silicon mold to cast Fountain pen bodies and caps Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: Yes Supports: Yes Resolution: .15mm Infill: 10% Filament: Any PLA Any Notes: Some of the models…
Drive pods are made from 1" extruded aluminum from Home depot. Drive motors are Hobbyking 25mm or 1000RPM equivalent Category: Robotics
This is designed to work with the Dryden Design replacement nib found on Amazon . Either the Hooded Fine Nib or the Medium nib will work with the body. You will also need 2 10mm x 2mm round magnets for the body and cap. When slicing this…
This is the first version of Tiger Shark. This may not be an exact representation of the robot but it is pretty close. As such the design may be incomplete and will need modifications on the final parts to get everything to fit. I don't…
This is version 2 of the frame and the first foray into 3D printing. You will notice in the video that the weapon is on the top instead of the bottom. It turned out I didn't have wheels large enough to make the robot sit level with the…
Drive motors: n20 Gearboxes Rubber on the wheels is from surgical tubing or Exercise band Fingertech ESC wedge was constructed from Small hinges and titanium Top and bottom plates were milled from G10 material Print Settings Printer:…
Version 5 Print Settings Printer: Creality CR-10S Rafts: Doesn't Matter Supports: Yes Resolution: 0.2mm Infill: 10" Filament: PLA PLA Category: Robotics
Version 3 of Tigershark The body was shrunk and used the fingertech 6in blade. 50:1 Spark motors Viper Horizontal Spinner add-on Fingertech Pulley Fingertech Belt Flanged bearing for weapon Fingertech hub for weapon…
The wheels that were used are from Hobbyking in conjuction with lite hubs from Fingertech. 50:1 Spark motors Viper Horizontal Spinner add-on Fingertech Pulley Fingertech Belt Flanged bearing for weapon Fingertech hub for weapon Print…
Drive pods are made from 1" extruded aluminum from Home depot. Drive motors are Hobbyking 25mm or 1000RPM equivalent Drive can be constructed by using the printable drilling templates Category: Robotics
These are all currently available results.
