P
Printablesplainoldcheese
Stratocaster Back Plate
I included the freecad file so that you can check that the screw hole spacing is correct for your guitar
- Downloads
- 351
- Likes
- 28
- Rating
- 0
All models
Counting matching models…
P
Printablesplainoldcheese
Hex Key Cap
A hex shaped keycap (I have not printed this yet and it may need custom keyspacing for everything to fit) I did model the stem 1:1 based on the spec sheet so you may need to print a few at +-1% to 5% to get a good fit.
- Downloads
- 146
- Likes
- 29
- Rating
- 0
P
Printablesplainoldcheese
Le Chiffre 40% Mechanical Keyboard (Handwired Version)
0.2mm layer height works fine for all the stls but you might want to use a finer one for the plates and a thicker one to make the case print a bit quicker. the holes are for m2 screws. I printed the bottom plates in transparent filament…
- Downloads
- 115
- Likes
- 27
- Rating
- 0
P
Printablesplainoldcheese
Crystals
Some abstract crystal shapes I made in blender. Maybe you can make a lamp 🤷
- Downloads
- 68
- Likes
- 6
- Rating
- 0
P
Printablesplainoldcheese
Kind of OK AeroPress Stand
The first useful model I made. I don't like storing my AeroPress with the tubes inside each other because my first AeroPress' rubber got damaged that way. I used tinkercad. I printed mine with too few walls because I was impatient. I also…
- Downloads
- 27
- Likes
- 2
- Rating
- 0
P
Printablesplainoldcheese
jeeboard
A mechanical keyboard plate/case generator using openSCAD. Generates a 3mm plate (5mm to be tested) with switch clips for any sized keyboard. It uses an array of switch positions and supports 2u stabs. the file jeeboard2-grid.scad takes…
- Downloads
- 26
- Likes
- 4
- Rating
- 0
These are all currently available results.