Counting matching models…
Router bit holder for both ½", ¼", 3/8 and 8 mm bits. The ¼" version is available in a 6x6 or 3x6 configuration. The others in 5x5 or 3x5. Doesn't need to be super strong so PLA and low infill are fine. This is a redesign in OnShape of…
These are bench dogs with a non-slip top. You can use them to hold the workpiece above the MFT table for sanding and finishing. They also work well for cutting. The shaft is 19.5 mm as they don't need a tight fit. I've cut a lot of sheet…
This wall mount works for the Sena 20, 30 and 50 series as they all use the same cradle style. Most will want the double mount but I needed a triple so it is included. I printed it laying down and used no supports on my Creality CR-6SE.…
This is an organizer for 20 mm bench dogs. The holes are 20.5 mm for a relaxed fit. There is a 6x6 and a 6x3 version. Easy print with no supports or even a brim.
A simple holder for 10 markers. These fit the two sizes of dry-erase I had as well as the standard Sharpie. It could be held with double-sided tape or the 3M Command Hook strips. I used adhesive backed magnetic strips. Printed with a brim.
These are brackets that allow you to mount the Marc Parnes wheel balancer to wooden uprights. Not absolutely necessary but they do help the balancer from slipping off. There is some left right adjustment but try to get the spacing of you…
These are all currently available results.
