Counting matching models…
Use supports internally if you print it with the GOST threads on the build plate. Otherwise the valve might not work properly. The needle valve (unremixed) was printed with 100% infill.
Hello, this file is for two adapters, both female and male to connect a GP-5 GOST thread to rubber hose. The hose end is supposed to be 27mm in outer diameter, and 4mm thick. May fit slightly wider or thinner, by a millimeter or so, if…
This model is for a whetstone guide of 20 degrees grind angle. The model is made to fit a 103 x 32 x 6 mm stone. The example is printed in PETG. 0.1-0.2 infill Print without supports. The sled is best printed on its rear end. Edit: If…
Hello! This is a remix of the Valve Index Viper Stock by fletcherkinnear on Thingiverse (https://www.thingiverse.com/thing:5362506) I have modified the parts to accept 15mm tubing between them. You will need about 50cm of tubing. Start…
The red model. White is original. Orient to print as shown in the photos. Use supports on build plate. Here printed in PolyLite ASA.
Keeps together without any hardware for me. No supports needed. Mouse ears on the outer corners protected against warping for me.
This is just the enclosure to fit the following: Wemos S2 Mini 1.0.0 DHT22 - the version on a small board PMSA7003 - soldering the connector was a hassle, as it was not a standard DuPont connector but something half the size. SGP-41 on a…
I created from sratch a clip to hold the RPi 4 FLIRC case with the clip from https://www.printables.com/model/677437-en You need to print both to use this clip. The RPi holder goes all the way down to rest for stability against the side…
Holds 4 bottles of Diamine ink nicely. Three of the pen holes are made to fit a Lamy Al-Star cap. Recessed tray for your other crap. I use it in the office and it works great. :-)
Two variants available; 1.5mm and 0.75mm. Print at 100% infill. Remove the knob by pulling, mount the washer (chamfered side towards the knob for easier mounting if your dimensions are a bit off), and put it back. Voilá! The pressure from…
Hello! This model is for a stand to put your favorite IKEA Samla 22l box on top of your computer case. There is a parametric F360 file so you can make it suit your needs. The parameters for the computer case are marked as favourites in…
These are all currently available results.
