Counting matching models…
Printed lying on its face. 3 walls and 3 top/bottom. 15% grid infill. Very solid, but the pin version isn't great imo. For V2 you will need supports as shown in the photos.
Required parts: 2x M5 x 16mm 1x M3 x 12mm 1x M5 Washer 2x F695 Bearings The washer should go between the top bearing and the printed adjuster. Snug the M3 x 12mm screw, but do not tighten it. The bearings should spin freely. If you don't…
This was created to cover the hole where the exhaust fan was after I removed it. This will hold the hot air in the chamber better.
This mousepad is 204mm wide and 217mm long. The cup part is 84mm wide and 67mm deep. Resize in your slicer as needed. Print settings: 3 walls, 3 top and bottom. 15% grid infill. Made with PLA, but PETG should work fine.
Print with PLA or PETG settings: 3 walls, 3 top, 3 bottom 100% infill Support overhangs as seen in the photo Note: The Comgrow glass bed for the Ender 3 is a huge improvement that is well worth the money imo! If you prefer Aliexpress you…
These allow for the addition of M3x4Lx5W heat inserts. Mark the belt with a fine tip Sharpie or ballpoint pen and add/remove teeth as needed. Can be used to clamp the end of two belts to cut to length with exactly identical number of…
I plan to use these with ultra-thin screws, but so far only tested on button cap screws.
These are all currently available results.
