Counting matching models…
This carbon filter for the Creality K1 consists of multiple pieces that snap together to create the final product. Tolerances are 0.1mm so be sure that your printer is tuned appropriately. Filter sheets are a common 120mm x 120mm x ~10mm…
Tolerances are 0.1mm so be sure your printer is tuned accordingly. This design should ideally be printed in a temperature resistant material for longevity. I would recommend PETG or better when using the enclosed build volume or running…
Simple but sleek Bike Cable Clip designed to tidy up your Mountain Bike cockpit. Primary Hole is 5mm intended for brake line and the secondary holes are about 4mm intended for either dropper post cable or headlight/E-Bike wiring. Designed…
These brake line grommets were designed to secure aftermarket brake lines on Yamaha motorcycles. These parts specifically were made for the Gen 2 Yamaha FZ1 but should fit many other bikes in Yamahas line up and may fit other brands as…
This is an attachment I designed for the Milwaukee M12 HAMMERVAC to turn it into a portable desk vacuum. I regularly use this attachment on my project workspaces sucking up snipped wire bits, solder splatter, and filament support debris.…
I designed this part to be a direct replacement for the FLAD (Forward Lean Angle) Cube on my BentMetal Snowboard Bindings. My adjustment block broke midseason and couldn't find / didn't want to wait for replacement so I made this replica…
These are all currently available results.
