Counting matching models…
The Dish and Topdish are designed to fit together. Dish2 and Topdish2 hold a full size soap bar. Dish1 and Topdish1 is just a smaller version of the same design. Dish1 may not fit all soap bars, but most soap designs would probably work.…
Looks like the scoop changed designs and is now smaller. I will have to update this when I have time. No supports necessary. You could print big circle down and let the printer bridge the gap. Took 50 minutes for my print settings. To…
No supports. Print this in the orientation shown in the cura picture included. I decided to make these mini alligator clips for my small jumper wires that came with my Elegoo Arduino Kit. Good luck! Solidworks design is also included if…
I used multiple versions of toothpaste squeezers and I have found that there are aspects that I like about each one. I enjoy a highly optimized squeeze because I don't like waste. I like the simplicity of the split shaft, and I like the…
This is my OCD Remix of DSW_design's sd card holder. Changes in solidworks: SD-Outer-d: Removed edge text for cleaner look. SD-inner-1: Leveled out the thumb holes for better more even finish on the final print. For Print: Flip SD-Outer-d…
Earcups are too close for my ears, and it gets painful to listen for a long time, so I made a solution for us to use. The design is symmetric for both earcups. Took me 3 tries to find out the best way to print this, 2nd picture shows the…
This version is designed to fit the more fancy square bars of soap. I have found that my previous design is too short from front to back to fit a Dr Squatch bar. I know of other square bars, and hope they will fit for you too! Pro-tip:…
These are all currently available results.
