Counting matching models…
Resin Drainer/ Filter for the Anycubic Photon M3. Created this two part design that should not only allow you to leave the vat to drain (it shouldn't tip, over, the photos shown is also with a totally empty bottle), but allows you to use…
Custom FEP Frame for the Photon M3 that should allow you to use your own FEP sheet with it. Uses M3 4mm Screws & M3 x 2.5mm L x 5mm OD Heat Inserts Printed In PETG, Allows me to uses nFEP with my Printer Category: 3D Printer Accessories
Print 4 parts in order to form a full spacer, the parts are designed with a simple interlocking system that allows it to slot into each other, technically no need for glue etc unless you want it to be permanent. Designed as close to 1:1…
Cable clip for Generic Microphone Monitor arms like the cheap kinds you'd get from Amazon etc. Works for those flat cables as well, most of the other cable clips that I've seen here do not do that. They work with Square arms with 10mm x…
Thumbsticks for the Moga Hero Power, it's a bit of a tight fit but it does go in with a small amount of coaxing. I originally did this to try and replace my worn and broken original thumbsticks, but I thought to myself that I could do one…
Hot Shoe mount adapter for the Zhiyun Smooth Q. Design is snap on, just slide in from the rear, it'll snap in, then lift the front latch and push backwards to remove it. Designed to fit small and light devices on top (lights, microphones,…
Requires a decently well calibrated printer. I apply a bit of cyanoacrylate accelerator to the white bit on the inside of the syringe then pretty much put a healthy amount of superglue onto the center peg of the printed plunger. I printed…
Vanguard's tripods have pretty horrible hinges. They break super easily and aren't very lasting. I've got the Nivelo 214BK and so this is modelled after the hinge of that but it should be the same for all. Made in 3ds Max, tried to get it…
Just like how the Hinges for my Vanguard broke, I guess it was about time that the underside base cracked as well. I however, don't like throwing stuff away that I feel still has use in them, so I dedicated a few hours to building this to…
These are all currently available results.
