Counting matching models…
After I dropped my titan the first time I tried to look for a replacement battery door but you need to buy the entire mod again, which I did the first time. Then came 3D printing in my life. Fun as hell! But of course, my precious new mod…
This has been what I needed for so long and I had yet to find one. Here it is, the final piece of the bathroom practicality puzzle. 3mf file made in PrusaSlicer with supports. Install with either double sided tape or 2 flathead screws for…
Made them for my MB42X to get a better soundstage on my desk. I used a very wide brim to get maximum adhesion.
This rework is : -Stronger as you can adjust the settings/orientations for each individual parts -Easier to print -no supports needed Printing with a higher amounts of perimeters as well as more top and bottom layers is going to help for…
Bottom has a tendency to warp so I add circular tabs (in cura) before printing. Also a brim will most definitely help. Letters are definitely too tight, maybe a 98% scale would help
These are all currently available results.
