Counting matching models…
This is an electrical connector to allow a non Anker Battery to be used on the F3800 battery unit. NOTE: This is NOT UL Listed, Not Approved by Anker! The reason that I created this model is because I have seen others successfully connect…
I needed a clamp that could clamp as little as one piece of paper, and as much as 8mm. This hemostat does that. I used a 3mm screw as my pivot point. Fun design project.
Some non Bambu filaments use the same settings as Bambu filaments. I thought it would be nice if I could mark my favorite filaments as Bambu, and allow the AMS to read it directly. The attached are modified spool rings that allow you to…
I needed a hearing aid case to protect my hearing aids when I travel. I figured that I'd add storage capability for four batteries (315), and enough room to store a silicone pack from a filament box. As a fun note, my friend asked if it…
On the Bambu Labs X1C Carbon, to reach the rear lead screw to clean it. This uses a toothbrush for deep cleaning
I saw this model made in wood many years ago. I couldn't find it online, and frankly, I couldn't think of what to call it. If anyone knows the original designer, please let me know and I will give him credit. Anyway, I remembered the…
I use this to hold a thermos and two pens on my wheelchair. It is prethreaded for two ¼-20 thumb screws. I find it very handy. When my wife and I are out on walks, or traveling, I use two! Thumb screws make it very easy to remove and…
This is a bracket to hold poster tubes (for holding blueprints, artwork, scrolls, etc) to a wall or cabinet. it is made for 3.4" diameter tubes. it requires a slight amount of flex, so I used PETG. It's a simple design, but stores the…
These are all currently available results.
