Counting matching models…
the original part was broken in a way that it could not hold the compartment door closed properly anymore, so i modeled a similar part to replace the OEM part, this one does the job well and was a quick print.
this is made for 5.5mm rod , but it will work with 5mm and 6mm rod as well most likely. i printed it with cura slicers best quality preset (0.12mm), a bit less quality will likely work but id recommend to print this with high quality as…
my mouse cable kept rubbing the edge of my table and getting a bit of wear, i decieded to make a cable bungee that sticks to a wall with 2 sided tape. its made of 2 parts which are the base and the cap, if the cap wont stay on you can use…
These amplifiers stock mounts are made out of weak and low quality plastic, you can print these to serve as a stronger alternative. you will need to print 2 of each to replace both stock mounts as this one is in 2 parts, also there is…
Originally made to fit a DD Audio VO-CT45 into an unknown horn, the mounting was just 2 bolts, i was too lazy to get the distances right so i decided to solve 2 problems with a single shortcut, i made the mounting holes accept a small…
TPU recommended heavily, comes with a small cap to cover the hole. Only tested on the Audi A3 8P, likely fits any car where you can screw this into. (and where the depth is not much off.) The USB extension cable needs to have specific…
This is a remix of another model i tried to print for myself, but had issues with it. (It wanted to tip over and bend when i put some books on it) I added legs to keep it upright and reinforced it on the wall side so the books weight…
This possibly fits other VAG car models too, but i haven't verified it.
These are all currently available results.
