Counting matching models…
After 4 years rubber bands on my Sjopenna Lamp got stretched to a point that it was falling apart. I found this model , but it was for the table lamp, so I created a set of similar clips in Fusion 360. To replace all rubber bands you'll…
I created this model to mount Skadis boards to the back of my Fredde desk. Thank you @yaczesuaff_544976 for the idea of using knobs as attachment points. Required parts: Fredde desk 56x56 Skadis 76x76 Skadis 4 top connectors 4-5 bottom…
Remix of the official LLT Screwdriver holder that can be mounted to an Ikea Skadis board with the low-profile T-Clip .
Printed in PLA, 0.16 layer height, 4 walls, 25% gyroid infill. Can be printed both standing or laying on the back with snug supports for the pins.
Fits multimeters up to 89mm X 54mm if mounted with low-profile clips .
These are all currently available results.
