Counting matching models…
Insert for Milwaukee Packout 48-22-8435 Recommend printing in red ASA or other robust plastic, I used 0.2mm layer height with 3 wall loops, alternate extra wall, 7% honeycomb infill. I had to slice it to fit on my Bambu X1C 256mm print…
Drew up a new powder measure knob for adjusting the powder charge for a Dillon RL550B reloading press. Uses an M3 screw to secure it against the flat part of the bolt head. Recommend printing using PLA with 0.08mm layer height to get the…
M-Lok handguards in 4.5in and 9in lengths. Shown on a Midwest Industries 12.625in 308 rail. Printed using matte PLA and 0.08mm layer height. I haven't yet run these through their paces, so it could be that a more robust/higher-temperature…
I tried some other caps out there, but didn't like them, so I drew a new one from scratch. Note that there seem to be plugs with different depths, so this will fit some but not all. Made two versions: rev A: 0.46in height (see image) rev…
My son wanted a toy baking/cookie sheet for his toy kitchen, so here it is. Printed in PLA
I wanted a simple box to store boxes double-edge safety razors to keep them organized and together in my bathroom drawer. Printed using PLA using 4 walls and 0.2mm layer height. Suggested improvements: Make slots for a divider so when…
My son has a Black & Decker brand toy drill and screwdrivers. I was looking for a set of screws he could play with, and liked the model linked below, but the slot on the screw was too small to fit the fat tip of the screwdrivers and drill…
The tracks on my old Tonka Front End Loader were lost to time, and so now that my son and nephew are playing with the Tonkas again, it was time to replace the tracks. Has a directional track, and an internal chamfered alignment groove to…
Replacement bumper for SB-1664FN Bostitch finish nail gun. Printed with TPU 95A 0.16mm layer height Turn up walls, shell layers, etc. so it prints solid Some support is necessary - print with the skinny flat side on the build plate (as…
To be used with 1.5" diameter baby gate supports, to be installed against ¾" tall x ½" deep quarter-round. 2024-12-18 update: while PLA stays in place fairly well, TPU might be better from a grip standpoint.
These are all currently available results.
