Counting matching models…
Should be compatible with Logitech Headsets G230, G231, G332, G430, G432, G930 but only G332 was tested, and works perfectly. I used Prusa Mini+ with Prusament PLA and default “0.10mm DETAIL” settings in PrusaSlicer. Original author:…
Split to two parts so it can be printed on my Prusa Mini+. I've used Prusament PLA with default 0.2 QUALITY settings with supports. It was my second Fusion360 model, so appologies for not the best parametric source file. Stand is…
For latch itself, I used a piece of wood ( 20mm x 20mm x 300mm ), held by 6mm furniture screw. To hold latch in upper position I used magnet ( diameter 10mm ; height 2mm) in printed magnet holder. Printed using Prusament PETG on my Prusa…
My contribution to 10" MINI RACK at https://github.com/geerlingguy/mini-rack Compatible with https://www.printables.com/model/358304-fully-printable-half-width-server-rack-and-trays rack. I removed the corners of the panel to print it on…
Housing and radiation shield for Aqara Temperature and humidity sensor (Zigbee) WSDCGQ11LM with double wall. The model was specifically designed for 0,4mm nozzle in mind, with very conservative overhangs, so no supports are needed. It was…
Instead of mounting Prusa Original Enclosure's panels from inside, mount them from outside and secure with magnets. You can remove them easily at any time. You will need 8 magnets per panel. The panel holds nicely even with fewer magnets,…
I've used "Holder Hexagons (40mm)" by @kerngebiet to make a simple shelf. It is a bit harder to install, because you have to have a "90degree screwdriver", but with some creativity...
My contribution to 10" MINI RACK at https://github.com/geerlingguy/mini-rack Compatible with https://www.printables.com/model/358304-fully-printable-half-width-server-rack-and-trays rack My requirements were: open panel for ventilation…
Printed with PLA (0,2mm SPEED) with 5% Cubic infill. Canopy has place for a magnet, same as original, but can be also fastened using a velcro.
This is a ridiculously simple model. I used it when I was learning to model in the Onshape 3D editor. Source: https://cad.onshape.com/documents/be8ee93347bc30fb526870a3/w/2d7506cffdfd8429e25d6fb7/e/cd4f88f6b1b5f8c65b5918a5
I used the right part from Fusion model, and mirrored it in Prusa Slicer. Printed using Prusament PETG on my Prusa Mini+ - no supports needed . (Used default "0.20 Draft" + 3 perimeters setting in PrusaSlicer)
Deflection guide wheel for sliding gate to prevent the gate from scratching the brick fence. I have very limited space at the gate (25mm and 15mm from the fence), so I had to design my own model. Very simple but funcional design. This is…
Casio CSP100 piano comes with quite heavy power supply. It just hinders everywhere. So I created a simple PSU holder to pin the PSU to piano's wooden frame.
Flying Insect Light Trap Refill compatible with RAID Essentials Flying Insect Light Trap. Use a strong double-sided carpet tape. Use the cheapest PLA filament you have, with 0.2 mm layer height. White or light-blue color works best.
These are all currently available results.
