Counting matching models…
After receiving my BTT Manta board I decided to design a better version that was also more printer friendly. In this design the board floats in the middle of the body with two lids for access on both sides. I have also added cable…
My Attempt at making a case for the BTT M5P Case for my Prusa Bear Printer, Has 2 x 40mm fan mount points, I think they will fit inside but if not outside is good too. Mounts onto 2040 extrusion. Not printed yet. Newer Version:…
this is a rework of the original EVA3 5015 fan mount so that is doesn't protrude so much. I have a toolboard where the cable relief goes so i had to put a bit of an angle on the fan attachment.
These are all currently available results.
