Counting matching models…
Not the most well put together model but it printed great how it is. This model has the note at the bottom, as you can see in the pictures. The print in the picture was printed at 0.17mm, supports, 20% infill and 120ish grams of PLA,…
This print has a few files but you only need two or one depending on how you want to print this. Scale to 500% or to what you'd like Print the whole thing together with model 1 > GTI KEY CHAIN FULL PRINT - 1 Print fully without key hole…
The original by edreplicas on cults was split into too many pieces and would fall apart over time if under frequent stress. It would also be difficult to get measurements perfect for all pieces to align properly. I optimized it to print…
I printed at 0.2mm's with 10% infill with great results. Feel free to print at different settings to try things out. You can also scale it however you'd like. Please like the model if you enjoy it! I made this model because I hadn't seen…
How I printed: - Modified the gcode in Cura to pause at the desired heights for manual filament changes. - 0.16mm layer height - 20% infill - Supports must be used for the key ring. - Glue must be used for the multipart model. I recommend…
These are all currently available results.
