Counting matching models…
This is a remix of the excellent Orange Pi Zero 2W case by Gremlin87. I loved the original case with an integrated antenna clip inside, but I wanted it to snap onto my Ender 3 extrusion, so I modded the design to allow that and then made…
I was looking for a good macro pad for video editing. I came across Zack Freedman's youtube and big wheel repo. I couldn't find a teensy in my project budget, so I updated the design to fit a generic/clone of the Pi Pico. I also hollowed…
I combined the thoughtfully designed Amazon Basics/Denali Electric Screwdriver Wall Mount by @yipottery_2481232 and the ingenious Sy's Peglock - Locking Pegboard System by @StellasFun to arrive at a pegboard mounted holder for the Amazon…
Basic mount for a Biqu Microprobe which stacks into the mount holes for the 10mm cable management tower.
Certainly a specific use case, but someone asked for an upload so here it is. This tablet mount slides into the iFit slot on top of a NordicTrack treadmill and holds a Fire 8 inch tablet in a case securely. The tablet should fit snugly…
I bought this super inexpensive frame for my first home made build, only to realize I didn't do enough research. The 1103's I bought didn't fit the mounting holes, so I created some simple adapters to make them fit the 3-hole pattern.…
I needed something to stop the pipes from banging into the cabinet when I ran the water pump in my RV. Since the wood was too thin for screw mount and I didn't want a hole in the cabinet, I just dropped 2 clips onto a flat base the right…
The LED surface mount lights in my office didn't have a diverter, so I made one. Uploading to share based on a few requests. Including the .f3d file in case you need to modify the mount to fit your light.
I wanted something to cover this lock so I wouldn't accidentally scratch my tailgate with one of the sharp corners. This is a very simple sleeve design but it gets the job done and I put some little ridges on the edge to grip the beveled…
These are all currently available results.
