Counting matching models…
Remix of the Low-Poly Bulbasaur to fit a small succulent pot from IKEA with a drainage hole in the bottom. Pot Dimensions are: Upper diameter: 52mm Lower diameter: 40mm Diameter below rim: 48mm Rim height: 10mm Total height: 52mm Printed…
This is a rim brake pad alignment tool designed to help you toe-in your rim brakes. By doing so this tool will add a slight tilt to your brake pads to avoid squealing and screetching sounds when braking. Designed with little hooks and a…
Sunlu S1 filadryer filament guide that can be printed on the side for increased strength from layer orientation and can be fitted with an M10 PTFE coupling.
A headrest for bedframes and mattresses works with both professional headrest pillows, travel pillows and rolled up towels. Can be disassembled for storage and transportation. Attention: For the bedframe mount you ll need to check your…
Remix of https://www.thingiverse.com/thing:2763764
Version 2 of my headrest for bedframes and mattresses works with both professional headrest pillows, travel pillows and rolled up towels. Now more sturdy and and with a lip to hold towels and travel pillows in place. Can be disassembled…
To be used with PTFE couplers with an M6 thread.
After my first print in PLA of the original Kryptonite mount broke I decided to redesign the mount to be more sturdy. Since the failure happened along the layer lines at the height of the lower bar of the "U " I flipped the print…
Monitor stand legs fitting for an IKEA Linnmon table so you can put a monitor stand onto it. For those that like things in ultrawide. Requires an 18mm thick wooden board that is as wide as the table and some M4 Spax screws.
This is a stylish divider for the Ikea Komplement drawers for those that want to create additional compartements. Takes about 6-8hs and 250g to print. Can be Printed in Multicolor or Singlecolor. Min. Bed Size is 256x256. (X1C or…
I mostly use 0.05mm for leveling for best results. I aim to get a very slight resistance when sliding the feeler under the nozzle from side to side.
Small peg that attaches to the Portland Basil front rack so that you can attach your cycle light below the rack where it can shine without being blocked by your cargo. Requires an M3x16mm screw, washer and nut.
I mainly designed this cupholder for my boardgaming table where the lip wasn't big enough for a grip. This cupholder feels very stable and should prevent accidental spillage incidents. It can be stored away when not in use. I added the…
Small holder for a hairdryer that attaches to a Lillangen/Fuller washbasin cabinet without any screws.
Requires 1 608 bearing and 3 M3 screws.
Simply print this, then pop out the old overly tight bitholders and pop in the new printed ones. I included the F360 file in case you want to tweak the size of the hexagons to your liking.
Snap fit divider for the Ikea Hultarp mesh container. May also work with the non mesh containers
These are all currently available results.
