Counting matching models…
I wanted a build plate holder that could handle multiple plates, and mount on multiboard without feeling like it would pull off if I pulled out a plate badly. Features of this holder: Five slots, 1.2mm deep. Will hold even my thickest…
Solder sucker holder that mounts to a multiboard with a single push-fit connector. Prints easily without supports. Print in “upside-down” orientation. Pictured model printed in VoxelPLA Pro Magenta on a Bambu Labs A1 Mini
The Sovol zero uses two pieces of PTFE tubing between the print head and the filament runout sensor, connected with a double-ended tubing connector. It also has a bulhead fitting to feed the PTFE tube through the side panel. This piece…
Storage Bins to hold Kreg Model 320 Pocket Hole Jig and Accessories. Bins fit Harbor Freight Medium 20-bin Parts Storage Case. The bin for the jig itself is specific to the Model 320 jig. The Bin and tray for the Driver and Drill Bits…
This wrench is designed to fit the knobs on the Ridgid Benchtop Belt/Spindle Sander. One end is designed to fit the knob as it came from the factory. The other end is sized to fit the knob if the rubber cover is missing, removed due to…
The Sovol Zero uses a type of 1515 channel for its frame, but I've found that standard clips don't fit it. The channel on the Zero rails is narrower, and having the side panels attached outside of the rails make is so they would not clear…
Simple knife rack for holding straight utility knives. I made this for holding leatherworking trimming and skiving knives. Designed to hold knives with 2mm thick blades. Five slots are 30mm deep, and spaced 25mm apart. Attaches to…
NOTE!!! This model requires that you have the required NeoPixel Rings, microprocessor, and the skills and knowledge of how to use them. This print merely provides the parts needed to make them fit models designed for Bambu's LED Lamp…
The fill pipe of the Earthbox and Earthbox Junior self-watering planter is quite large in diameter, allowing debris, insects or even small creatures to fall into the reservoir. This cap slips over that tube, leaving only a very small…
Lid for Dripping Springs Ollas (DSO) Ollita model. I made this to fit 1/4"(6mm) drip tubing, so it can be filled automatically. A drip emitter should be used to reduce flow to prevent overflow. Tubing fits tightly, this is intentional.…
A very simple model. The Status LED on the ASUS BT10 / BE18000 is very bright, and cannot be dimmed, only disabled. This model allows the LED to be obscured, and depending on the filament and print settings used, can completely block the…
These are all currently available results.
