Counting matching models…
Holds Snap-on 14.4 Impact and Screw Gun Printed with 15% infill and used PETG for the one shown. The total print time on a Bambu was around 90 minutes, Ultimaker shows around 4.5-5.5 hours on an Ender 3 v3 SE with the same infill setting.…
We bought this Vizio sound bar a few months ago and our cats would turn the speakers and it was rather annoying to look at, I initially made some brackets to help that slipped over the original mounts but the wall they mount to is shared…
I bought a Ring Stick up for my patio. I made this cover for two reasons, to add a layer of protection and because I didn't want the blue “recording” light to be visible at night. It won't cover the lens, mic, or speaker, so it's still…
Purchased a Van Der Hagen safety razor and wanted a wall mount for it. I made some drain holes in it as well. I made two versions. screw mount and large command strip mount. If you pick the screw mount version I made it for a single #8…
Found this coupler for two screw in lid suave bottles. The shampoo I like isn't made in a larger pump bottle anymore, so I've been transferring them into one, but was tired of squeezing through the hole or lining the two up and making a…
I broke the camera glass on my iPhone this week. Thankfully I had Apple Care so it wasn't super expensive, just inconvenient to not have my phone for a few hours and having to reset everything again. So to avoid that in the future I made…
These are printed in place, and HIGHLY recommend using a .2 nozzle, use whatever settings you like beyond that
Masking tape holder to wall mount masking tape. I made mine in Petg because that's what was in the printer. This model is for a two inch tape roll. Step and Fusion files included modify as necessary. I printed it on the mounting surface.…
I made these fence post lights to add some decoration to the limited space I have at my condo. They are swappable for all times of the year, even a file for just a standard ball to go on them. I attached the Fusion and step files for the…
Set screw stripped on me, didnt like how loose it felt trying to shift. Made this to use the factory attachment screw. Super glue the plug in and then plastic weld the outside seam.
https://www.amazon.com/dp/B07WR4KBMF?psc=1&ref=ppx_yo2ov_dt_b_product_details Step File and Fusion 360 to modify
Fits Creality direct drive extruder Used Variable layer height to speed up print I have it in PLA for now until I get a new temp sensor that will read correctly so I can print in PETG. I would recommend PETG or higher heat-resistant…
This is 100mm calibration tool. I know it won't do you much good if you haven't gotten it close yet, but I can't fit my calipers in my enclosure very easily when they're set for 100mm, so I made this so I could check it easily or…
Our card box for relative insanity tore and needed something to hold them that was bit more durable. Fits the full deck with a little space to get them in and out easy. Has separate chambers for the red and the yellow cards. Lid fits semi…
These are all currently available results.
