11 models
This replaces the bottom case of the Lily58 and Lily58 Pro to give 15 degrees of tenting. Uses the original standoffs and M2x5mm screws to secure the top plate to the case. Stick 5 6mm diameter adhesive rubber feet to the indents in each…
Yet another keycap puller, this time in OpenSCAD. Use this to remove 18mm Cherry style keycaps without damaging the stem or stabilizers. You don't want to break your fancy keyboard while removing Hot Pocket and Cheetos crumbs, do you?…
Keeps loose 4-pin Molex power connectors in your PC from shorting against the case or other components. Instructions Print, snap, sleep better. Fits tight when printed with Kisslicer. Category: Computer
The Lamy Safari's cap is held together by a plastic screw going into a brass bushing. The screw is fragile and can snap if too much stress is put on the clip. This is a replacement for that screw. The thread in the bushing is M5, which is…
Have a missing button cap on your old HP or Agilent bench gear? Then I've got just the thing for you! Designed for my HP 3478a bench DMM, but should fit similar '70s - '90s vintage gear with 1/4" square pushbutton stems. Print Settings…
Adapts a phone with a standard 2 or 3 screw wall hanging mount to the modular Slatwall system found in some Steelcase cubicles. Instructions Print with moderate infill and extra perimeters. Screw in 2 or 3 self-tapping PC case fan screws…
Remix of @Gracro's Balun One Nine case to fit the V2.0b3 board revision. You may need to clip the leads on the back side of the board in order to get the lid to close properly.
I modified Kuro's excellent MK7 based geared Bowden to use an M5 or M6 BSPT pushfit connector. The hex nut retainer channel is gone, replaced with a bolstered hole for the pushfit. Instructions BOM is the same as Kuro's, but replacing the…
These rack mount ears are designed to fit the Seneca Element MP digital signage PC model with built-in power supply. They will fit in either direction without blocking intake or exhaust vents, and can be swapped so that the connectors can…
A simple parametric case for the Intel Edison Breakout Board kit. Use it as-is for working with the Edison without I/O, or modify the .scad to make it fit your project. Uses a one-piece pushbutton extender for pressing the power button…
Jig to solderlessly attach to the CPU debug pins of the Hubsan Q4 or Estes Proto-X quadcopters for hacking. Useful for working with bradwii firmware. My Proto-X looks like it has a conformal coating over both side of the board, including…
These are all currently available results.
