Counting matching models…
I was inspired by the fridge magnet contest, and I have been wanting to have a better place than the junk drawer for the sticky notes. So I designed this. I made a right handed and left handed version depending on how you want to grab the…
A classic science tool to let you trap a vortex and observe it forever. Fill one bottle with water and screw on the adapter. Screw on another bottle. Put the water filled bottle on top and give it a little twist of the wrist and watch the…
I made this hook to hang up the bicycle helmets. It's simple and strong. It can also be used to hang whatever else you want to. Print on it's side no supports and thicker layer lines for more strength.
I just wanted a way to make the input wires area a little more clean looking so I whipped this cap together. The screw holes are a bit undersized so I could drill and tap to fasten directly into the material. Print Settings 0.2 layer…
I designed this case to be a standalone setup. it has spots for 2, 80x80mm, pc fans such as the Noctua nf-a8. I incorporated several tie down spots for cable management and 20mm holes to rout the cables in and out. I have proved the…
I had an esp32 devkit and 1.28 tft round display in my parts bin and thought I would load up the Bigtreetech Knomi code to see how it works and was pleased enough to make it a case to house the kit. I figured, why not share it for anyone…
I made this fan duct to help direct a more focused air stream to where it's needed. I designed it to have a BLTouch and the option to design a different fanduct and not need to remove everything. Just unscrew the 2 screws and install the…
This is a custom case to hold the Bigtreetech HBB macro button board and the KNOMI V2. You could use the stand to have a better desktop item, or without. There are some other holes to allow for alternative mounting. I used M3x10 screws to…
My print example is at 40% because I didn't have enough material, but it still worked well after working in the threads. I recommend using support in for the bowl part as I didn't and it would have came out better with supports on. At…
I wanted to use an SKR 2 motherboard in my Anet ET4 so I made this simple mounting system. Its a slightly unconventional position but it works well and I was able to use the original ribbon cable, with some new terminations until I get to…
This was an experiment to see if I could do a tensegrity thing… well its not really tensegrity but its close and hangs nicely. Its designed to be printed at 0.2 layer height and no supports (as long as your setup can handle long bridging.…
This is just a project I'm doing to dial in my BIQU-B1 with the 2in1 hotend upgrade and at the same time learning to use Fusion 360. The insert part is ment to be in a transparent filament to let the LED shine through, but you can of…
This is a pocket to hang on a square hole pegboard. (8mm x 8mm holes with 30mm spacing between holes) this will fit a 3 hole x 3 hole area. Supports on recommended to help with the hooks. I use rafts because I don't have a heated bed.…
Print as you please. I recommend extra walls to help with watertightness. It shouldn't need supports. The image I posted is printed at 50% original size.
These are all currently available results.
