P
PrintableskinoX51
Coincell Box CR2032 + CR2025
I needed the organizer without the LR44-Part so I cut that part out of the design. Printed in PLA Thanks Blubberlutsch for the initial design! :)
- Downloads
- 92
- Likes
- 8
- Rating
- 0
All models
Counting matching models…
P
PrintableskinoX51
Parkside Performance Mower Cable Holder
I've lost one of my cable holders for my Parkside Performance PPRMA 40-Li A1 Mower. This replacement was tested in PLA and in the end printed in ASA due to it's heat resistance. Most likely PLA or PETG will work as well.
- Downloads
- 88
- Likes
- 12
- Rating
- 5
P
PrintableskinoX51
Tactile Switch Buttonhead
I needed a simple TactileSwitch Buttonhead for a 6x6x3.4mm TactileSwitch. Designed in Fusion360, tested on Geeetech PLA. Fitment was OK but not too tight so a drop of glue should held it in place.
- Downloads
- 75
- Likes
- 9
- Rating
- 0
P
PrintableskinoX51
PiKVM Rackmount with ezcoo 4-Port HDMI Switch
I found the rackmount from “cjdawson_com” interessting and build it myself. I had a few problems with the keystones not holding correctly. So I merged the Keystone Panel Mount from “M” with the original model and also added a few extra…
- Downloads
- 50
- Likes
- 17
- Rating
- 5
These are all currently available results.