Counting matching models…
Automatic Klipper/Spoolman configuration with RFID-tags This model is part of a system I use to select Spoolman spools from RFID tags attached to spools in klipper. Klipper can then verify that the right filament is used before printing…
Buttons that fits in Voron's hexagonal skirt holes. 12x12mm through hole buttons are used. I think I used these . Connect them to free GPIO pins. The Raspberry Pi usually have a few free ones if the control board is maxed out. One cable…
This is a mount for the Beacon 3D rev H scanner fitting the Voron 2.4's X carriage for Afterburner for the dragon hotend. The plate is just thick enough to fit normal M3 thread inserts. Mine was printed with bambu lab's default “strength”…
A simple case with a slide in lid for adding a PN5180 NFC reader to a Voron. The parts should be turned upside down for printing. I printed the Top with tree support for the cable hole, but it might not be needed. There is a connection…
A simple box to hold the sleeved cards for Bohnanza 25 years edition. The box is roomy enough for the coin as well, but that's it. The top/bottom is really too thick, 3mm, but it was good enough for me. The parameterized onshape model is…
This is a simple bowden tube holder and runout sensor with the Voron logo. It replaces the original bowden tube holder. The sensor is a micro switch. The model also needs JST connectors, four M2x10mm self tapping screws and some cables. A…
Hold a 6-pin needle connector with this model. The dimensions are for one of our PCBs, but the OnShape model here is parametric so it is can be changed for other PCBs.
My treadmill didn't come with any automatic lubrication system so I designed this system. A rubber hose was cut with small holes along one side, clamped to each side of the treadmill band and a funnel was mounted on the side of the band,…
I saw a video of a plotter recently and thought why not use the printer as a plotter too? The result was this pen holder that fits on the front of my AB-BN Afterburner. I hope it also fits the original Afterburner. If not, the slightly…
A simple enclosure for a USB RS485 interface. The onshape model is available here .
A simple gadget to make the air inlet hole in the plaster look nicer. The model is made parametric and made in Onshape. Its available here . I printed it with fuzzy skin and tree support. A whole forrest surrounded it during printing.
The Ergon GP1-L handles are around 11mm too wide for my Brompton M handlebar. I made this jig so I could cut them straight off. Printed with 0.2mm layer height and support for the small gap.
I needed a bike mount for my Fairphone so I can chase those Strava records... I printed it in PLA upside down with traditional supports on the build plate only, but it can probably be printed on its open edge too, saving support material.…
These are all currently available results.
