Counting matching models…
Easy print. The chainlink has built in support ,other parts need support. I will provide the rest of the parts with built in support… Print with ABS 0.2 or 0.12 Layer height and should be fine… Nozzle 250 Bed 100 in my case… You can open…
I have LED strips laying around and PSU was not a big deal to find for it. There is a transparent print in the model. I printed all parts with ABS (the strip has some heat) You can solder LED strips(4x) in paralel then just connect it to…
This is a remix, because i did not have 9x5 magnets but 6x3. Also i changed the housing of the rotor to click in. This way it just hold in place, but can rotate as need. The 6x3 neodinium magnet hold the tool just fine. Print Settings…
No Support needed. Already in print orientation. Tested with ABS. 0.2 LayerHeight 0.4 Nozzle You can test Your printer Calibration with this.
Needed some at weekend this was the fastest solution.. Layer height 0.2 Nozzle 0.4
Easy to break the original part and unavailable the replacement at the moment. Print Setup: 0.2 layer height 0.4 nozzle ABS Put a piece of filament (about 10mm) and glue it into the small hole as you see on the second picture.
I've made of ABS+ no support needed to print. Layer height 0.2- 0.3
This is a stand for Miele Motif Dispenser with extenders (10mm and 20mm). I design this to make always the same quality prints on the coffe :) You can use it with cups with different height with the extenders. Print Settings Printer:…
content 3 pieces 2 washer 1 adapter. U need to cut out a bit from the cw2 enclosure so Ucan plug the connector of the toolhead. No support needed. nozzle 0.4 layer height 0.2
These are all currently available results.
