Counting matching models…
I designed this model after finding no good rubber band planes. It's simple and should only take 24 minutes. After printing, clean up the support material on the propeller with a pair of pliers. Then, sand down the shaft and put it in the…
This is a traditional bamboo copter. It's simple and prints in 23 minutes. I would suggest printing it on its side because printing it upright leaves the shaft very weak. TPU is too heavy and PLA is too brittle. I would suggest using…
I love the rubber band gun by the The_Creatologist But I found that it was uncomfortable and didn't have a barrel long enough for my rubber bands. This remix incorporates all of these features and it is a better model. Here are some print…
These are some twists and turns for my marble run. You will have to print them with support but they should work well. Have fun and enjoy!
These are all currently available results.
