Counting matching models…
I wanted some clips to stop my 1/4"(0.25") peg board hooks from falling out when I took the tools off. I also made one for 1/8"(0.125"). The board I used them on are 1/4" holes with 1" spacing Print Settings Printer Brand: MK3 Printer:…
I needed a plug for my camper garden hose hook up. Screws in easy and works great. Category: Tools
Repetier couldn't handle the amount of detail on the original so I decimated it to have have fewer polygons. You can see the low resolution and high resolution side by side in one of the pictures. It is bigger then I thought, you can see…
How to train your dragon toothless door knob kitchen cabinets.
I added some 3D steps to the 8 bit Mario to give it some more detail. Then, I printed the JPG on paper and glued it on after cutting it out with a craft knife. Category: Art
The little electric screwdriver has enough torque that I couldn't hold it during use. I made a grip and then I conjured a stand and bit holder as well. The larger bit holder will hold all the bits and then some(30 holes). I like the…
Need to drill some holes in a pipe at 90 degrees, how about 120. Use this to grip the ID of the pipe and rest on the table to align the hole. No hardware or support are need! Works with nominal pipe 1.5", 2", and 2.5" schedule 40. Come…
This is a latch that mounts perpendicular to the to the camlock. Martin already had a good design on a camlock so I used his and just designed my own latch. https://www.thingiverse.com/thing:2601090/files Print Settings Printer Brand:…
A latch so my 10 month old can open the door. The hole in model doesn't print well so I drill the hole out with 1/16 drill bit and used a piece of 1.75mm filament as the hinge and melted the end to hold it in place. Category: 3D Printer…
I made this to fit on a 1x4 with a flange wood screw from McMaster. I don't like using flat head wood screws in plastic because if you over tighten them they split the part. I couldn't find any wall hook board off the shelf that had…
T handle allen set holder with counter bore for magnet feet. Sizes: 3/8, 5/16, 1/4, 7/32, 3/16, 5/32, 9/64, 1/8 Magnet - http://www.mcmaster.com/#5862K14 Screw - http://www.mcmaster.com/#95893A218 Print Settings Printer: DaVinci Supports:…
These are all currently available results.
