Counting matching models…
3D scan file of motocross helmet scaled to 1/10 of the original. There are some faults in the file, especially in the bottom edge and under the sun visor, but it is still perfectly usable for RC-buggy driver etc.
Wheel rim with 10mm offset for Traxxas TRX-4M High trail. This wheel will fit the original tire and offsets the wheel about 10mm outward from original. These wheels will put higher stress for your steering, so some upgrades for servo…
Phone stand for phones using thick protective case like Otterbox or similar. Stand has two different angles to get good angle for video calls or viewing. It also has a slot for the USB cable to have your charger or other accessories…
Garden wind whale for visual wind speed and direction display. You will need to print all the parts included exept the stand that is optional. You can use the stand, or you can put wind whale on top of any round pole that is under 15mm in…
Cooler grid to be put on bottom of the cooler to keep your food and drinks from getting wet. This grid will raise things inside your cooler for 25mm (about an inch) to allow accumulated water to stay away from the food and drinks etc.…
Window blinds adjuster connector for two part adjuster arm to replace a broken one.
Simple window blinds adjuster holder to replace a broken one.
Weather station housing for DIY weather station sensors. There is two versions. One with the holders and one without. Middle sections you could print as many as you need ( example in the pictures has two ). There is also a sensor holder…
These are all currently available results.
