Counting matching models…
Just a quick camera enclosure / stand I whipped up for my Raspberry Pi. Be aware: this enclosure does not fit the v1.3 camera! Print instructions Category: Camera Summary Just a quick camera enclosure / stand I whipped up for my Raspberry…
Remix of model by Paul-Vincent Roll. Made to be mountable on regular wall with screws instead of on pegboard.
Set of espresso puck rake and holder. Print with brim to avoid them detaching during print. For the puck rake I use regular acupuncture needles. Unfortunately the ebay listing isn't available anymore - or I would have provided a direct…
Shroud / casing / stand for the Rev.C OV5647 Camera for Raspberry Pi. Same sensor as in the original (v 1.3) Raspberry Pi camera, but with a proper lens. More about this camera can be found here:…
Stand that fits one Pullman Bigstep Tamper and one OCD v3 (Ona Coffee Distributor). There are two STL files to choose from. The original model has a loose fit for the tamper (62.5 mm diameter) since I prefer not to damage the edge.…
I needed to mount the HC1 on the wall so I made this. Print two, one for the top and one for the bottom, and slide them on.
I had two EspressoBins laying around and needed an enclosure. Lets you pair an 3.5" SATA drive with the SBC. Be aware that I have designed this around the first release of the EspressoBin (v5 I believe). If you have a v7 I can't guarantee…
These are all currently available results.
