Counting matching models…
Print amount for full board game (small variant): Castles of Mad King Ludwig: 48x 1000, 30x 5000 For sale: 84x 1000 Coins are defined in attached openscad source and it is easy to define your own sizes and denominations there. Note: you…
Template for drawing dinosaurs. Good bed adhesion is needed - PLA will need a well-cleaned plate and may be simpler to print with PETG. The figure outlines are properly sloped so you can draw the figures accurately regardless of angle of…
There are several pre-generated variants with reasonable parameters you can just use. Or you can use the OpenSCAD source to generate your own variant by simply altering the parameters. The important parameters: number of slots for lab…
Remix (thinner monolith, better lower part with shield) of original Monolith by Adam Stansbury. Included OpenSCAD that uses original model as include and performs the necessary modifications on it.
5 Variants of Egg cup. Printable without supports. Parametrizable with source in OpenSCAD (default size is suitable for chicken eggs). Parameter $egg_width and $egg_height affect the egg dimensions for which the cup is a tight fit. Change…
Replacement part for broken overfill cover in an old bathtub. With default parameters it fits a system with 42mm or slightly larger hole, where it is screwed with a single screw to the pipe on the other side. You can open the source in…
Hex tile holder. With default height (68mm stack), two of those holders are just sufficient to hold all hexes from both 2 large and 4 small Eclipse expansions (1st edition). Source in OpenSCAD, so it is possible to easily generate…
3D Orbital replacement suitable for 1st edition of Eclipse. Well stackable, similar outer dimension as the original paper ones. Possibly suitable as replacement for 2nd edition of Eclipse if you lost some of the original ones OpenSCAD…
When I was printing ships and starbases for 1st edition of Eclipse, I found some usable ships ( https://www.thingiverse.com/thing:3141223 ), but not many usable starbase (only 3) designs to have a different one for each race. So I decided…
Define width/height/depth in OpenSCAD file as necessary. You can also set the diameter of holes for insects and increment of the size for each row (can be set to 0 to have all holes with same size) The design will auto-fill the hotel with…
Cedule "Nevhazujte letáky" k nalepení na schránku. Její přítomnost obvykle výrazně snižuje množství letáků nacpaných do schránky. Pro správný vzhled je nutné přidat do poloviny tisku změnu filamentu. Prusa-slicer umí toto detekovat a po…
Alternative set of hollow pieces for HedronStack balancing game. You can see through them, if you print with transparent filament, you may be able to see through the sides partially as well. You can either replace original pieces with the…
These are all currently available results.
