Counting matching models…
If bees fall into your paddling pool then this raft provides a place to climb on and dry before flying off. Printed in PETG. A modifier is used to remove the top and bottom layer in the center section, generating the pattern. 10% infill…
A simple stand for the Nintendo Switch Pro Controller. My first original print after getting my Bambu P1S. I've used the fuzzy skin feature for a nicer texture.
A WDT that looks good on the countertop! Printed with fuzzy skin for more grip. The filament used was ABS but this should work with PLA as well. I glued in needles similar to these ones which I had still lying around.
See https://www.printables.com/model/382058-bambu-ams-disconnect-tool This is a combination tool to help disconnect the PTFE tube and the AMS cable. This remix has 6x2mm magnet holes instead of the original 6x3mm magnet holes and no text.
A divider for round trash cans with a 295mm outer diameter. This trash can divider comes in three sections that can be screwed together for a tight fit on the trash can. There are two variations: 295mm bin Outer diameter 295mm Rim width…
A small tray for succulents or other plants. The cross pattern keeps the plants from sitting in water after soaking them. I printed these in PETG. Beware that there might be issues with stringing because of the pattern. With a Bambu P1S,…
A clip for labeling Ikea Komplement boxes. Clips over the folded-over sides and holds labels that wouldn't stick to the felt. I printed these in Matt PLA but most materials should work. There's a normal profile which should print fine. If…
A stand for the C3 Ocarina from Hans Rotter / Ocarinamusic. The curve follows this Ocarina but others might fit as well. TPU strips prevent the Ocarina from sliding around. Glue them into their respective indent. A compartment in the base…
Bird feeder attachment for a balcony with a 16cm wide rail. I'll attach the drawing so you can change the height or width according to your railing if needed I recommend printing in PETG or another material that has a bit of flex and can…
A small table with 3d printed legs and a wooden tabletop. Print settings: 0.16mm layer height 10% gyroid infill to save on filament leg base needs supports printed with PLA In addition to the printed parts you will need: A wooden…
Organiser insert for the small Ikea SKUBB box. Fits into the box nicely and has a cut-out for the zipper in one of the corners. Printed in matte PLA.
These are all currently available results.
